How to Inspect a Used Film Camera Before Buying: A 15-Minute Checklist

Fifteen minutes with a battery and a scrap roll of film will catch most of what goes wrong with used film cameras. Here is the exact checklist.

What you need before you start

Fifteen minutes and four items will catch most disasters: a fresh battery of the correct type, a scrap roll of film, a small flashlight, and a phone with a light-meter app. Everything on this list can be done on a shop counter with no tools.

The 15-minute checklist

1. Battery and power (1 minute)

Install a fresh battery and confirm the camera powers on and the meter responds. A camera that seems dead with a fresh battery has an electrical fault, not a flat battery.

2. Shutter at every speed (2 minutes)

Open the back, hold the camera to a light source and fire through the speeds. You should hear and see a clear difference between 1s, 1/8, 1/60 and 1/500. Slow speeds that hang or sound identical are the classic sign of a shutter needing a service.

3. Film advance and rewind (3 minutes)

Load a scrap roll and advance three or four frames. The lever should pull smoothly and wind evenly, and the rewind crank should turn when you press the release. Slipping advance is a gear-train problem and usually means the camera is a parts candidate, not a stock candidate.

4. Light meter against a known reference (2 minutes)

Set the film speed, point the camera at an evenly lit wall and compare the suggested exposure with a phone light-meter app. Readings within one stop are normal for a vintage camera; dead or wildly erratic meters need a calibration.

5. Lens: haze, fungus and scratches (2 minutes)

Open the back, set the slowest speed and the widest aperture, then look through the lens with the flashlight behind it. A faint haze that wipes off the outside is fine. Spiderweb fungus inside the glass, or coating etching, is permanent and spreads — walk away.

6. Light seals and mirror (1 minute)

Check the foam seals around the door and along the mirror edge. Crumbling, sticky foam means light leaks until replaced — a cheap fix, but it must be priced in.

7. Viewfinder and focus (2 minutes)

Look through the viewfinder for debris and fogging. If the camera has rangefinder or autofocus, verify focus against a known distance. A misaligned rangefinder is invisible in photographs until the film is developed.

8. Exterior and frame counter (2 minutes)

Run the frame counter through several frames, test the self-timer, and check the tripod socket and strap lugs. Cosmetic wear is normal and gradeable; missing or stripped parts are not.

Red flags: walk away from these

What this checklist does not cover

A passing grade here means the camera is mechanically sound, not retail-ready. Professional preparation adds new light seals, calibration against instruments, full lens cleaning and individual documentation. That difference is exactly what separates a unit that sells at a premium from one that comes back as a return.

Frequently asked

Can I trust a camera that has been stored for years? Often yes, if it passes the checklist. Storage cameras most commonly need new light seals and a meter check. Anything with a slipping film advance or fungus inside the lens is rarely worth restoring.

Is a dead light meter a dealbreaker? Not always. Meter repair or calibration is a standard service, but it must be priced into your wholesale cost. Treat a dead meter as a discount, not a disqualifier, unless the camera is intended for parts.

How long does professional preparation take? A standard batch is prepared and documented within days of order confirmation: testing, light seal replacement, cleaning and individual condition reports before shipment.

Ready to stock these models?

We supply tested, individually documented film cameras to retailers in the US and Europe, with unit-level inspection reports shared before balance payment.

Request Wholesale Quote